Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable Dryer Vent Cleaning Across Wells Branch
Dryer vent cleaning in Wells Branch typically runs $180-$340 for a standard single-family home, with most jobs completed in 90 minutes and a written price delivered before any work starts. We’re familiar with the 1980s-era homes that dominate this community, and our crews dispatch from the Austin office to reach Wells Branch properties without the scheduling delays that come from out-of-area operators.
Call (737) 259-5752 for a free written estimate. Every visit includes a Documented Photo Record of your vent run, before and after, so you can see what was actually removed versus what a shop-vac noise might leave behind.
Why CleanRun Air Duct Cleaning Round Rock Is Wells Branch’s Preferred Dryer Vent Cleaning Company
We’ve served the Wells Branch market since 2013, and the pattern here is unmistakable. The community’s near-universal 1980s tract build means original attic flex duct is now 35-45 years old, and on dryer-vent calls here we routinely find the same failure the duct side has - collapsed inner liners and joints pulled off plenum boots - so a vent job often turns into a repair call. That predictability is actually an advantage: our technicians arrive with Guardsman sealing components and Nikro camera equipment already on the truck, not as add-on surprises. If the damage is too extensive, we also offer Air Duct Cleaning in Wells Branch to fully restore your system.
Our Dryer Vent Cleaning in Wells Branch customers receive the same documented standard we hold everywhere - written price before work, photo record after, and the 365-Day Done Right Promise backed in writing on every job. Haven Standard Clause 1 requires it.
Scheduling is coordinated from our Austin office, and we route crews to Wells Branch without the lag of operators based in San Antonio or Houston. Most Wells Branch appointments book within 48 hours, not two weeks.
Our Dryer Vent Cleaning Services in Wells Branch
Dryer Vent Inspection
A proper inspection in Wells Branch starts with a camera run, not a flashlight glance. We scope the full vent pathway from the dryer connection to the exterior cap, looking specifically for the collapsed flex-liner failures that are routine in this community’s 35-45-year-old housing stock. The inspection documents what the camera sees - sagging inner liner, separated plenum boot, packed lint behind a collapse - and produces a written scope with pricing before any cleaning or repair begins. Haven Standard Clause 1: written price before work, no exceptions.
Vent Cleaning
Our Dryer Vent Cleaning team uses Rotobrush agitation tools and negative-pressure extraction (a suction system that pulls debris out rather than blowing it around) to clear lint buildup from the full run. In Wells Branch, this often means working past a partially collapsed section to restore airflow, then addressing the structural failure that caused the blockage. The job isn’t complete until we verify airflow and negative pressure at the cap - a measurable standard, not a guess.
Lint Removal
The lint that escapes your trap doesn’t vanish; it packs into elbows, sags in low points of flex runs, and accumulates behind collapsed liner sections where no homeowner tool can reach. In Wells Branch’s original 1980s flex duct, we regularly pull two to four gallons of packed lint from a single run - material that has been building for years in a pathway the homeowner never sees. We photograph every pile before removal and the clear passage after.
Vent Rerouting
Some Wells Branch homes were built with dryer vents routed through attic flex duct in ways that no longer meet current safety standards - long runs with multiple elbows, or pathways that terminate in soffits instead of exterior walls. Rerouting these systems through shorter, rigid-metal pathways reduces fire risk and improves drying performance. We quote reroutes in writing with a diagram of the proposed new run, not a verbal promise.
Vent Cap Replacement
Wells Branch’s cedar and oak pollen seasons - December through February for Ashe juniper, March through May for oak - coat vent caps with sticky debris that traps lint against the screen and backdrafts moisture into aging duct insulation. We stock replacement caps with proper backdraft dampers and bird-resistant screens, sized to fit the 4-inch rigid or flex runs common in this community’s housing stock. Installation is quoted upfront and photographed on completion.
Bird Guard Installation
Central Texas bird activity peaks in spring nesting season, and uncovered vent caps in Wells Branch’s mature-tree neighborhoods attract sparrows and starlings regularly. Our bird guards are steel-mesh cages that maintain airflow while blocking entry - not the plastic knockoffs that squirrels chew through in a season. We install them as standalone calls or add them to any cleaning or cap replacement.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Wells Branch
We run professional-grade equipment from trade-recognized brands: Rotobrush agitation systems for mechanical lint breaking, Nikro for negative-pressure extraction and HEPA containment, and Honeywell airflow meters for post-job verification. For HVAC systems, we also service Trane in Wells Branch and other major brands. For repairs and replacements in Wells Branch’s aging housing stock, we stock Guardsman sealing components and Aprilaire cap assemblies - parts a homeowner can look up independently rather than take our word for. We don’t roll up with hardware-store shop vacs and call it duct cleaning.
Common Dryer Vent Cleaning Problems We See in Wells Branch Homes
- Collapsed flex liner behind the plenum boot. On a dryer vent call off Bratton Drive, our tech pulled the vent run and found the flex inner liner had partially collapsed behind the plenum boot, invisible from the register - exactly the failure mode we see across Wells Branch’s same-age housing. We ran a camera inspection, cleared the lint pathway, re-secured and sealed the run with Guardsman components, and verified negative pressure and airflow at the cap before closing the wall - the dryer finished a load dry on the first cycle.
- Summer attic heat degrading joint seals. Attic temperatures above 140°F in July and August bake the adhesive and tape seals on original 1980s flex duct, opening joints that become lint traps. The dryer trap catches only the coarse material; fine lint packs into these gaps and hardens over years of heat cycling.
- Pollen-plugged vent screens. Wells Branch sits in the Central Texas cedar corridor, where Ashe juniper releases some of the heaviest pollen loads recorded in North America each winter. That pollen coats vent-cap screens, sticks to damp lint, and forms a mat that restricts airflow far more than lint alone. We see this every February and March.
- Original vent runs too long for modern dryers. The 1980s construction standard in Wells Branch often used 20- to 25-foot flex runs with two or more elbows to reach distant soffit or roof terminations. Today’s higher-efficiency dryers can’t push adequately through that resistance, extending dry times and overworking heating elements.
Pricing for Dryer Vent Cleaning in Wells Branch, TX
Standard dryer vent cleaning in Wells Branch runs $180-$240 for a single-story home with accessible attic or crawl space and a straightforward vent run. Jobs that require camera inspection, collapsed-liner repair, or plenum-boot resealing - common in this community’s 35-45-year-old housing - range $260-$340. Vent rerouting, cap replacement, or bird guard installation are quoted separately in writing based on the specific configuration we find.
| Service | Wells Branch Price Range |
|---|---|
| Standard vent cleaning (single-story, accessible run) | $180-$240 |
| Vent cleaning with camera inspection and minor repair | $260-$340 |
| Vent cap replacement with bird guard | $120-$180 (add-on to cleaning) |
| Vent rerouting (new rigid-metal run) | $340-$520 (quoted after inspection) |
Every price is written and agreed before work begins - Haven Standard Clause 1. No per-vent pricing, no coupon bait-and-switch. Call (737) 259-5752 for a free written estimate.
We Also Serve Cities Near Wells Branch
Our crews work Wells Branch properties regularly and also cover neighboring communities including Round Rock, Brushy Creek, Pflugerville, and Hutto. Scheduling and dispatch are coordinated from our Austin office, with route optimization that keeps Wells Branch appointments on time without the overhead of a satellite location.
Serving Wells Branch, TX - Our Local Coverage Area
We’re based in the Wells Branch area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Dryer Vent Cleaning in Wells Branch
Restricted airflow is the cause in nearly every case we diagnose in Wells Branch, and the restriction is usually a collapsed flex-liner section or packed lint behind a separated plenum boot - not the trap. The 1980s flex duct in this community’s original housing stock sags and separates after four decades, creating a blockage the homeowner can’t see from the laundry room. We scope it, photograph it, and quote the fix in writing. Call (737) 259-5752 for an inspection.
For Wells Branch’s 1980s-era homes with original flex duct, we recommend annual inspection and cleaning every 12-18 months - more frequently if you dry heavy lint producers like towels or pet bedding. The combination of aging duct materials and Central Texas pollen loads accelerates buildup beyond what newer rigid-metal systems experience. We document each visit’s findings so you can track degradation over time. Call (737) 259-5752 to schedule.
Yes. Most Wells Branch homes are slab-built with attic-mounted mechanicals, and many original dryer vents run through long flex paths that no longer perform adequately. We can reroute through shorter rigid-metal runs with direct exterior termination, improving both safety and efficiency. The scope and price are written after camera inspection, not estimated over the phone. Call (737) 259-5752 for a written quote.
Our inspection covers the full vent pathway from dryer connection to exterior cap, using a Nikro camera system to document the interior condition. In Wells Branch, we specifically look for collapsed flex liner, separated plenum boots, and pollen-mat buildup on the cap screen - the three failure modes we see in this community’s same-age housing. You receive the photo record as a standard deliverable, with a written scope and price before any work proceeds. Call (737) 259-5752 to book.
Yes, particularly in Wells Branch’s mature-tree neighborhoods where nesting pressure is high. Our steel-mesh bird guards and backdraft-damper caps prevent blockages that force dryers to work harder and longer, and they exclude the moisture that accelerates mold growth in aging flex-duct insulation. We quote cap replacement and guard installation as add-ons to any cleaning, with the price in writing before installation. Call (737) 259-5752 for details.
Ready to see what’s actually inside your vent run? Call (737) 259-5752 for a free written estimate. Every Wells Branch job starts with a documented inspection, a written price under Haven Standard Clause 1, and concludes with a photo record of what we found and what we fixed - backed by our 365-Day Done Right Promise.
Written by Tomas Reyes, Owner at CleanRun Duct Repair & Cleaning, serving Wells Branch since 2013.